Software Canon EOS R7 Professional

Details

• Canon Adjustment Software for EOS R7 requires Windows 7, 8, 10, or 11.  Emulations are not supported.
• Experience user-friendly 'Help'! Every section is linked to the feature you are currently using.
• Discover detailed information by checking out the Slide Show located at the bottom of this page.
• 1st time buyer?  Experience our ‘FREE Demo Software to explore the product before making a purchase

 

 

Software Canon EOS R7 Professional

Essentail and Two Plugins

Essential	Plugins
General	Shutter Calibration
Error Codes	Main Board Replacement
Calibration Data
User Settings
Camera FAX Report

Essential

General:

• Read the Model, Firmware version, Shutter and Release Counts.
• Change the Shutter and Release Counts through the Shutter Calibration Plugin.
• Read and Change the Serial Number.  Caution: Using anything other than an authentic Canon Serial Number may damage the camera.

 

Error Codes:

• Read the last 8 internal Error Codes and their probable causes.
• Know the Date, Release Count, and Lens in use when the errors happened.
• Clear the Error Codes following your service.

 

Calibration Data:

• You can use a "Good Used Board" without Initialization by transferring Calibration Data from your old Main Board.
• New Main Boards must be initialized using the Main Board Replacement Plugin.

 

User Settings:

• Download the User's settings and restore the settings after adjustments or repair.

 

Professional CameraFAX:

• Before and After Report for your customers!
• Data from your camera and plugins creates this detailed report.
• Headers and Footers can include your contact details, business information, logo, and warranty details.

 

Professional Plugins

Shutter Calibration

Shutter Timing:

• Review and adjust the Shutter Timing:
  • When replacing the Shutter, its high speed Timing needs to be adjusted.
  • When replacing the Main Board without the original Camera Data.

 

X Contact Timing:

• Review and adjust X Contact Timing:
  • If needed when you replace the Shutter
  • If needed after replacing the Main Board.
  • In cases where customers report vignetting in flash photos.

 

Shutter Count:

• Review and change the Shutter Count:
  • When installing a new shutter, reset the shutter count to '0'.
  • When using a good used shutter, set the count to match the count on the used shutter.
  • Review / Reset the count when replacing the Main Board without the original Camera Data.

 

Shutters Replacement History:

• Do not Reset unless the camera's original data is lost. Shutter Replacement History is an important measure of the camera's use. Note: Altering the shutter replacement history breaches trust.

 

 

Release Count:

• Do not Change unless the camera's original data is lost.  Release Count is an important measure of the camera's use.  Note:  Altering the Release Count  breaches trust.

• Understanding Shutter, Mirror Counts and Histories
• Understanding Shutter, Mirror and Total Count

 

 

Main Board Replacement

Backup Calibration

• Backup Calibration BEFORE REMOVING THE FAULTY MAIN BOARD.

 

Initialize Board

• Initialization is REQUIRED when installing a New Board.

 

Load Calibration

• Upload the cameras original calibration file into your new Main Board.

 

Model and Serial Number

 

These features are not needed if you have uploaded the camera's original calibration file!

• Change the Electronic Serial Number to match the label on the bottom of the camera.

 

• Make sure the Sensor ID on the Main Board matches the one on the Sensor PCB for the defect map. If they don't match due to missing Calibration Data, click 'Copy ID of Main Board' to sync them. For visible defects, send the camera to Canon for the correct defect map.

 

• If your Main Board was purchased from a different geographic location, use 'Change Model Name' to match Model Names in your location.